Crusher production line daily maintenance precautions:
Machines are old cattle, working hard in daily production activities, and bringing a steady stream of wealth to the majority of bosses. In other words, as long as it is the production of the machine, it is necessary to pay attention to the usual maintenance and maintenance, the cow can not just work without eating grass, do not pay attention to the maintenance of the machine, a long time, is to go wrong.
Today, based on the daily production experience of Shandong Sanxiang Heavy Industry machinery, we will talk about the maintenance and maintenance of the crusher stone production line.
First, the daily maintenance of the linear feeder is mainly to observe whether there is dust accumulation in the spring and the place in contact with the machine mouth, if there is, it should be cleaned up in time, and the soil screening function should also pay attention to cleaning the soil near the screen. Linear feeder vibrator adopts through structure, usually inside the thin oil can be used for a long time, pay attention to observe whether the oil seal seal is not good or damaged oil seepage, and through the oil hole whether there is a lack of oil, timely discovery and timely solution.
Second, after the general production of the crusher, the bearing should immediately hit the butter, with two-thirds as the benchmark, less bearings are easy to hold, more easy to heat. Pay attention to observe whether there are signs of loosening of the screw of the crusher shell, if there are more than a few times, remember to use welding drawings to save trouble. At the same time, pay attention to observe the wear of the wearing parts, and replace the problems in time.
Third, the circular vibrating screen mainly checks whether the screen is damaged, whether the screen body is cracked, the lubricating oil use of the bearing, and timely discovery and timely solution.
Four, the belt conveyor is usually mainly to check whether there is a phenomenon of leakage and deviation, whether the steel frame is cracked, the degree of wear on the belt surface, and the need to be replaced in time.
Fifth, clean up the leakage in each position in time, and find out the reasons to prevent further leakage.
Six, the dust removal pipe in time to check whether there is blockage.
Seven, timely check whether the dust removal system is working normally, maintain the normal operation of the dust removal system, and adhere to green environmental protection production.
Eight, always wear a helmet.
In short, Shandong Sanxiang Heavy machinery reminds you that in the daily overhaul and maintenance of the machine, it is necessary to do frequent inspection, timely maintenance, and maintenance in place, so as to make this old cow willing to produce and work more for you.